Tel : +86-13812850975 E-mail : info@winsoarst.com
Views: 0 Author: Site Editor Publish Time: 2026-07-11 Origin: Site
Watch the Winsoar medium diameter PE pipe line running test, then review the recommended layout for irrigation main pipe, water supply pipe, drainage pipe and cable duct production.
This solution is built for 75-250mm PE / HDPE pipe projects that need a practical balance between output, workshop length, cooling capacity and cutting quality. It is usually selected for medium diameter straight pipe production rather than coiled pipe production.
The page helps buyers check the real running condition before asking for a quotation. It also explains the main equipment sequence so the line can be matched to pipe diameter, SDR, material grade, voltage and available workshop space.
For accurate quotation, Winsoar can match the extruder, die head, vacuum calibration, cooling, haul-off, cutter and downstream receiving equipment according to pipe diameter, SDR, wall thickness, output target, voltage and workshop layout.
For farms and water-saving irrigation projects that need stable pipe diameter and reliable continuous production.
Suitable for HDPE pressure pipe projects where pipe surface, roundness and fixed-length cutting are important.
Can be configured for cable protection pipe or drainage pipe according to material, diameter and wall thickness.
| Process | Main Equipment | Selection Point |
|---|---|---|
| Extrusion | Single screw extruder | Selected by material grade, target output and maximum 250mm pipe diameter. |
| Mark line | Optional color marking co-extruder | Useful for project identification, water pipe stripes or cable duct markings. |
| Pipe forming | PE pipe die head | Matched with 75mm, 110mm, 160mm, 200mm, 250mm and required SDR range. |
| Sizing and cooling | Vacuum calibration tank and spray cooling tank | Cooling length should support straight pipe stability and line speed. |
| Pulling and cutting | Haul-off machine and chipless cutter | Used for stable traction and clean fixed-length cutting without excessive chips. |
| Receiving | Stacker or receiving table | Selected according to fixed pipe length and workshop layout. |
To prepare a suitable 75-250mm PE / HDPE pipe extrusion line solution, send Winsoar the pipe diameter range, SDR or wall thickness, pipe application, material grade, target output, voltage, fixed pipe length or coil requirement and workshop layout.
For full technical parameters and product details, visit the 75-250mm PE Pipe Production Line product page.
Share your pipe range, SDR, output target and layout. Winsoar will recommend a practical HDPE pipe extrusion line configuration.
